Husqvarna 530iPX Manual Del Usuario página 14

2. Check the saw chain. Never use blunt, cracked or
damaged equipment.
3. Check that the product is in perfect working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately lubricated, refer
To lubricate the cutting equipment on page 21 .
to
6. Check that the saw chain always stops when the
engine is idling.
7. Only use the product for the purpose it was intended
for.
8. Make sure the handle and safety features are in
order. Never use a machine that has any parts
missing or has been modified in relation to the
specification.
To start the product
1. Push and hold the start/stop button until the green
LED is on.
2. Use the power trigger to control the speed.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Push the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Push the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED is off.
14
3. Push the release buttons on the battery and pull the
battery out.
To fell a tree
• Do not fell trees into uncleared areas.
• When you cut, do the work in the 9 to 12 o' clock
sector.
• Recommended maximum diameter for the trees to
be cut is 15 cm / 6 in.
• A stump at the waist height can make the tree fall in
the target direction as far as possible.
• When you cut with the push stroke and pressure, the
tree falls rearward in relative to the guide bar.
• When you cut with the pull stroke, the tree falls
forward in relative to the guide bar.
• Use the guide bar to steer the tree into the target
direction of fall. For large trees, use the branch hook
behind the guide bar.
• Make sure that the tree falls after the trunk is cut
through and before you move the product.
General work instructions
WARNING: Be careful when you cut a tree
that is in tension. It can spring to its former
position and hit you or the product, and
cause injury.
• Do a check of the work area.
• Clear an open space at one end of the work area,
and start the work from there.
774 - 003 - 28.05.2019