Husqvarna 530iPX Manual Del Usuario página 15

• Work systematically to and fro across the area,
clearing a width of around 4-5 m/13-16 ft on each
pass. This exploits the full reach of the machine in
both directions and gives the operator a convenient
and varied working area to work in.
• You should plan the strip so that you avoid going
over ditches or other obstacles on the ground. You
should also orient the strip to take advantage of wind
conditions, so that cleared stems fall in the cleared
area of the stand.
• On sloping ground you should work along the slope.
It is much easier to work along a slope than it is to
work up and down it.
• If the stems are tightly packed, adapt your walking
pace to suit.
• If the machine is operated at temperatures below -
10°, the product and the battery must be stored in a
heated space for at least 24 hours before starting
work.
To use the product
WARNING: Do not stay directly below a
branch that is being cut. This can result in
death or injury.
• Be careful when you operate near overhead power
lines. Falling branches can result in short-circuiting.
774 - 003 - 28.05.2019
• If possible, position yourself so that you can make
the cut at right angles to the branch.
• Cut large branches in sections. Note that falling
branches can bounce in the direction of the user
after hitting the ground.
• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack!
• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from "jumping" on the branch.
15