Optional Accessories - Comet K 250 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

• spray gun;

• lance hose;

• professional fixed fan-shaped nozzle;

• water inlet quick-fit connection kit;

• external detergent suction hose kit;

• handle for transporting and manoeuvring (Classic model);

• handle fixing kit (Classic model);

• instruction manual - safety precautions;

• instruction manual - operation and maintenance;

• warranty certificate;

• after-sales centre booklet;

• EC declaration of conformity;

• nozzle cleaning pin.

In case of problems, contact your dealer or an authorised after-sales centre.

The standard fittings of the high-pressure cleaner can be integrated with the following range of

accessories:

•

type water mains disconnector: mandatory for connecting up to the drinking water mains.

• sandblasting lance: designed to clean surfaces, eliminating rust, paint, scale, etc.;

• drain cleaning kit: designed to unblock pipes and ducts;

• rotating-nozzle lance: designed to remove resistant dirt;

• foam lance: designed for more effective detergent distribution;

• lances and nozzles of various types.

• Put the power cable support (10) on the sheet metal plate of the handle (8) and fix it with the self-

tapping screw (11).

opEration

• Insert the handle (8) in the steel pipes projecting from the machine and fix it using the kit supplied:

tighten the threaded handwheels (12) on the nuts retained by their housings on the handle.

. 2

of fig

• In the Classic model, connect quick-fit connection (22) of hose (20) to the water outlet connection.

. 5

opEration

of fig

• In the Classic model, screw up the connection (21) of the high-pressure hose to the thread (18) of the

spray gun (13) and tighten well using two 22 mm fixed wrenches (not supplied).

• In the Extra model, screw the high-pressure hose connection of the hose reel onto the coupling (19)

of the spray gun (13) and tighten well using two 22 mm fixed wrenches (not supplied).

. 6.

fig

• Fit the filter (30) in the water inlet connection (29). Fit the seal (31) in the water inlet quick-fit

connection (32) and screw up to the connection (29).

• Move the high-pressure cleaner to work position.

• This machine can be used indifferently vertically (

• In the Classic model, Completely unwind the high-pressure hose (20).

• If your machine has a hose reel (5) release it by turning knob (27) anticlockwise; unwind enough hose

by turning the reel clockwise with the crank (26); lock the device by turning the knob (27) clockwise.

• Fasten a supply hose with inner diameter 19 mm/0.75 inches to the water inlet quick-fit connection (32),

using an ordinary gardening quick-fit connection.

• Open the water supply tap and make sure this is not dripping;

- if the connection is made to the drinking water mains, a

be used, in conformity with EN 12729 standard, and available from your dealer (

to its use, refer to the relative instruction manual;

- in case of supply from a water tank, introduce the suction hose inside the tank and make sure the vertical

distance between the water level and the pump is no more than 1.5 m (4.9 ft).