GreenWorks GPW1600 RC Manual Del Operador página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STARTING ANd STOPPING THE PRESSURE WASHER
C A U T I O N :
Do not run the pump without the water supply connected and turned on.
■ Connect the garden hose.
■ Turn the garden hose on then squeeze the high pressure trigger to relieve air pressure. Once a steady
stream of water appears, release the trigger.
■ After ensuring the On/Off switch is in the "0/OFF" position, connect the pressure washer to the power
supply.
■ Plug the pressure washer into the outlet and ensure the light on the GFCI is on, the unit is ready for
operation.
■ Switch the pressure washer to the "I/ON" position to start the motor.
■ To stop the motor, release the trigger and turn the switch to the "0/OFF" position.
W A R N I N G
Hold the handle and wand securely with both hands. Expect the trigger handle to move when the trigger
is pulled due to reaction forces. Failure to do so could cause loss of control and injury to yourself and
others.
NOTE: AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/Stop feature.
To operate: Turn the power switch to the On (I) position. Pump will pressurize and shut down
immediately. Once the trigger of the gun is depressed the unit will turn on. Unit will shut off and be in
standby mode when trigger is released.
SOAP APPLICATION
Soap is applied under low pressure high volume for optimum performance.
Soap can not be applied under high pressure with this machine
Soap / Detergent can only be applied with this machine when the detergent tank is installed.
OPERATION
EN - 17

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido