GreenWorks GPW1600 RC Manual Del Operador página 22

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING THE PRESSURE WASHER
Use only detergents designed for pressure washers.
Soap is applied under low pressure high volume for optimum performance.
Soap can not be applied under high pressure with this machine.
To clean:
■ Install the soap attachment on the spray wand.
■ Start the pressure washer and spray the
detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do
not allow detergent to dry on the surface.
To rinse:
■ Using the desired tip, spray away from the rinsing surface for approximately 10 seconds to allow any
remaining detergent to be flushed from the line.
■ Start at the top of the area to be rinsed and work down, overlapping the strokes.
MOVING THE PRESSURE WASHER
To move the pressure washer:
■ Turn the pressure washer off. Point the spray wand in a safe direction and pull trigger to release
water pressure.
■ Tilt the machine toward you until it balances on the wheels then roll the machine to the desired
position.
OPERATION
(See Figure 11.)
EN - 20
Fig. 11

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido