Mode Select - Peavey TRANSTUBE 258 EFX Manual Del Usario

(14) EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will
illuminate to indicate the selected effect. Rotating this control clockwise changes the
parameter of the active effect according to the descriptions below. The surrounding LED ring
indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS
Tremolo - Rate increase
Octaver - Wet/Dry mix
Flanger - Rate increase
Chorus - Rate increase/depth decrease
EFX amps are built with factory settings loaded into the presets. To return to the factory
settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning
the amp on.
(15) REVERB
This control adjusts the overall reverb level. The surrounding LED ring indicates level.
(16) DELAY
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1
repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the
control indicate which type is active and volume level. Pressing the control twice sets the
delay time to interval between presses.
FOOTSWITCH (NOT INCLUDED)
EFX
SELECT
MODE
17 18

MODE SELECT

The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode.
Pressing the MODE SWITCH (17) selects between the two modes. The active mode is
indicated by the MODE LED (18). Illumination of the LED indicates EFX Select Mode; a dark
LED indicates Preset Select Mode. Controls and indicators 19-24 perform different functions
relative to the active mode.
EFX SELECT MODE
NOTE: When entering this mode, the current preset will remain active.
In this mode, PRESET 1 (19) selects between the Lead and Clean channels. The CHANNEL
LED (20) will illuminate when the Lead channel is active. PRESET 2 (22) toggles between
two effects and their respective settings. This switch may be used as an on/off switch if one of
the settings has no effects active. To use the MODULATION LED (21) as a status indicator,
the "off" (or lower setting) should be made with the LED dark, and the "on" (or higher setting)
CHANNEL
PFC 3
1
PRESET
TO STORE PRESET
19 20
Funk Wah - Sensitivity increase
Rotary Speaker - Rate increase
Phaser - Rate increase
TM
2
DOUBLE-CLICK
7
MODULATION
3
PRESET
21 22
DELAY
REVERB
PRESET
23 24