Check The Installation; Customer Service - Thermador Freedom CIT30XWBB Manual Del Usuario

Code or Canadian Electrical Code and all local codes
and ordinances.
Attach flexible conduit to the junction box. Connect the
lead wires to the junction box supply wires in proper
phase:
black (L1) to black
▯
red (L2) to red
▯
green or bare to ground
▯

Customer Service

Contact Customer Service if your appliance needs repair
(see phone number below). Our Customer Service will be
happy to provide you with information about an
authorized servicer near you.
Model (E) number and FD number
When you contact Customer Service, please have the
Model (E) number and the FD number for your appliance
available.
You can find the rating label with these numbers:
in the appliance pass
▯
on the underside of the appliance
▯
You can also find the Model (E) number by accessing
the basic settings of the cooktop. You can check the
Customer Service index (CSI) and the FD number in the
basic settings. Please refer to the section on "Basic
Settings" in your Use and Care manual.
1 House power supply cord
2 Black wire
3 Junction box
4 Cooktop power supply cord
5 Grounded green or bare cable
6 Certified UL connector
7 Red wire
If the cooktop is installed and connected as specified
above, it will be grounded in compliance with the
National Electrical Code.

Check the Installation

CAUTION
9
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Remove everything from the cooktop surface including
stickers. Clean cooktop surface with cooktop cleaning
cream.
Switch on the circuit breaker.
Verify that elements function properly.
9