Trix 210 Serie Manual De Instrucciones página 7

Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix
or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• No automatic system recognition between Selectrix (SX) and
DCC.
• The full range of functions is only available under Trix Sys-
tems and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
Notes on digital operation:
• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once in
this digital system (Example: changing an address).
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• The values set at the factory were selected to guarantee the
best possible running characteristics.
• This locomotive comes from the factory programmed for the
digital address "01" (Selectrix) / "03" (DCC) Number of speed
levels that have been set: 28 (DCC) and 31 (Selectrix).
• Correct programming with the 66920 Mobile Station is possib-
le starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want
this characteristic, you must do without conventional DC power
operation (CV29 / Bit 2 = 0).
Safety Information
• This locomotive is only to be used with the operating system
it is designed for.
• This locomotive must not be supplied with power simultane-
ously by more than one power source.
• Please make note of the safety information in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for thispurpose. The interfe-
rence suppression set is not suitable for digital operation.
The necessary maintenance that will comes due with normal
operation is described below. Please see your authorized Trix
dealer for repairs or spare parts.
7