Intended Use; Items Supplied; Before Starting The Equipment; Parts Required - EINHELL HGG 110 Niro Manual De Instrucciones

Anleitung_HGG_110_171_Niro_SPK7:_
GB
3. Layout (Fig. 1)
1 Carry handle
2 Air inlet grille
3 Gas connection thread
4 Gas valve button
5 ON/OFF switch
6 Base
7 Housing
8 Piezo ignition knob
9 Air outlet opening

4. Items supplied

Open the packaging and take out the
■
equipment with care.
Remove the packaging material and any
■
packaging and / or transportation braces (if
available).
Check to see if all items are present.
■
Inspect the equipment and accessories for
■
transport damage.
If possible, keep the packaging until the end
■
of the guarantee period.
IMPORTANT
The equipment and packaging material are
not toys! Do not let children play with
plastic bags, foils or small parts!
There is a danger of swallowing or
suffocating!
Gas fan heater
■
Carry handle with 2 screws
■
Gas hose
■
Pressure regulator 300mbar
■
Original operating instructions
■
6
17.04.2012 9:38 Uhr Seite 6

5. Intended use

The gas fan heater is designed solely for
heating, structural drying and thawing purposes
in well ventilated rooms and outdoors.
HGG 110 Niro: Well ventilated rooms have
ventilation openings with a total area of at least
280 cm². A minimum room size of 112 m³ is
compulsory.
HGG 171 Niro: Well ventilated rooms have
ventilation openings with a total area of at least
450 cm². A minimum room size of 170 m³ is
compulsory.
The gas fan heater must never be used in
basements or in rooms below ground level. This
gas fan heater is not designed for household
use.
The gas fan heater may be used only for its
intended purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage
or injuries of any kind which result from such
misuse.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.

6. Before starting the equipment

6.1. Fitting the carry handle (Fig. 1)
Use a cross-tip screwdriver and the provided
screws to screw the carry handle (1) to the
housing (7).
6.2 Connecting to the gas cylinder (Fig. 2)

6.2.1 Parts required

The following parts are required to connect
the gas fan heater to the gas cylinder:
A conventional 5 kg or 11 kg (max. 13 kg)
■
gas cylinder.
A pressure regulator compliant with EN
■