Trix CC 40100 Serie Manual De Instrucciones página 7

Function
• SoftdriveSinus propulsion with a maintenance-free motor
• Built-in electronic circuit for operation with a conventional DC power
pack (max. ±12 volts), Trix Systems, Trix Selectrix or NMRA DCC
digital systems.
• Automatic system recognition between digital and analog operation.
• No automatic system recognition between Selectrix (SX) and DCC.
• The full range of functions is only available under Trix Systems and
under DCC.
• Headlights for the locomotive change over with the direction of
travel. They can be turned on and off in digital operation.
Notes on digital operation:
• The first time the locomotive is used in a digital system (Selectrix or
DCC), the decoder must be set for this digital system. To do this, the
decoder must be programmed once in this digital system (Example:
changing an address).
• The operating instructions for your central unit will give you exact
procedures for setting the different parameters.
• The values set at the factory were selected to guarantee the best
possible running characteristics.
• This locomotive comes from the factory programmed for the digital
address „01" (Selectrix) / „03" (DCC) Number of speed levels that
have been set: 28 (DCC) and 31 (Selectrix).
• Correct programming with the 66920 Mobile Station is possible
starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation with
opposite polarity DC power in the braking block. If you want this
characteristic, you must do without conventional DC power operation
(CV29 / Bit 2 = 0).
7