Special Maintenance; Diagnostics - EMAK Oleo-Mac BVi 60 Manual De Uso

repaired.
Only use original spare parts. Parts that are not of the
-
same quality could damage the machine and harm
safety.
WARNING! During maintenance operations, remove the
battery from its housing.
8.1 COOLING THE MOTOR
To avoid overheating and damaging the motor, the cooling air
intake grilles must always be kept clean and free from leaves
and debris.
8.2 MANAGING THE BATTERY
1. The battery must be stored in environments with
temperatures between 0° and +45°C. If storing the
machine in places where these limits could be exceeded,
remove the battery and store it in a suitable place.
2. During use, the battery is protected against total discharge
by a protective device that switches off the machine and
stops its operation.
3. The battery comes with a protective device that prevents
recharging if the ambient temperature is not between 0°
and +45°C.
4. The battery can be recharged at any time, even partially,
without the risk of damaging it.
8.3 STORAGE
At the end of each work session, thoroughly clean the machine of
dust and debris, repair or replace defective parts.
The machine must be stored in a dry place, protected from bad
weather and out of reach of children.

9. SPECIAL MAINTENANCE

Each maintenance operation not included in this manual must be
carried out exclusively by an Authorized Service Center.
Operations performed at unauthorized centers or by unqualified
persons will void all forms of warranty.

10. DIAGNOSTICS

What to do if...
Source of problem
1. When operating the switch, the motor does not start
Battery is missing or fitted
incorrectly
Battery is flat
2. The motor stops while working
Battery is missing or fitted
incorrectly
Battery is flat
3. Reduced duration of the battery
Conditions of heavy use with
greater current absorption
4. The battery charger does not recharge the battery
(red LED light on)
Dirty contacts
5. The battery charger does not recharge the battery
(no LED light on)
No voltage to the battery
charger
Defective battery charger
6. The machine vibrates abnormally
Broken or damaged impeller
Corrective action
Make sure the battery is properly
inserted
Check the charge status and
recharge the battery
Make sure the battery is properly
inserted
Check the charge status and
recharge the battery
Optimize usage
Clean the contacts
Check that the plug is
inserted and that there is
voltage to the power outlet
Replace with original spare
part
Refer to an Authorized
Service Center
GB
21