Troubleshooting - Bosch Wallscanner D-tect 150 Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dtect150_1609929X08_3-15.qxp_D-tect150 3/20/15 10:54 AM Page 16
Batteries empty
Batteries incorrectly inserted (wrong polarity)
Detection tool too warm or too cold
Wheel losing contact with the surface
Detection tool has been moved to quickly
Trouble Shooting
Issue
Detection tool cannot be switched on
Detection tool switched on but does not react
Display indication: "Slipping Wheel"
Display indication: "Speeding"
"Temperature over range"
"Temperature under range"
"Strong radio signal detected"
Remedy
Replace batteries
Check if the batteries are inserted correctly
Take out batteries and reinsert again
Wait until operating temperature range is reached
11
Press the start button
bottom wheels have contact with the wall while moving
the detection tool; in case of uneven walls, position a thin
piece of cardboard between the wheels and the wall
11
Press the start button
slowly over the wall
Wait until operating temperature
range is reached
Wait until operating temperature
range is reached
Detection tool switches off automatically. If possible,
eliminate the interfering radio waves, e.g. WLAN, UMTS,
radar, transmitter antenna or microwaves, then switch the
detection tool on again.
-16-
and take care that the two
and move detection tool

Publicidad

Tabla de contenido
loading

Tabla de contenido