Initial Operation - Bosch Wallscanner D-tect 150 Instrucciones De Funcionamiento Y Seguridad

Dtect150_1609929X08_3-15.qxp_D-tect150 3/20/15 10:53 AM Page 10
Inserting/Replacing the Battery
To open the battery lid 4, press the latch
direction of the arrow and remove the battery lid.
Insert the batteries. When inserting, pay attention
to the correct polarity
representation on the inside of the battery
compartment.
The battery indicator b in the upper status line on
the display 16 indicates the charge condition of
the batteries.
Note: Pay attention to the changing battery
symbol so that the batteries are replaced in time.
Please change batteries
When the "Please change batteries" warning
indication is shown on the display 16, the settings
are saved and the detection tool switches off
automatically. Measurements are no longer
possible. Change the batteries.

INITIAL OPERATION

• Protect the detection tool against moisture
and direct sunlight.
• If the detection tool was subject to an extreme
temperature change, allow it to adjust to the
ambient temperature before switching on.
In case of extreme temperature or variations in
temperature, the accuracy of the detection tool
and the display can be impaired.
• Do not attach any stickers or labels to the
sensor area 9 on the back of the detection
tool. Metal nameplates can affect the detection
results.
• Use or operation of transmitting systems,
such as WLAN, UMTS,
antenna or microwaves in the close proximity
can influence the detection function.
Switching On and Off
• Before switching the detection tool on, make
sure that the sensor area 9 is not moist.
If required, dry the detection tool using a soft
cloth.
Preparation
To remove the batteries, press on the back of a
battery as indicated in the figure on the battery lid
in the
(1). The front end of the battery is released from
5 the battery compartment (2), so that the battery
can easily be removed.
according to the
Always replace all batteries at the same time. Do
not use different brands or types of batteries
together.
• Remove the batteries from the detection
Operation
Switching On
– To switch on the detection tool, press the
– LED 17 lights up green and the start display is
– When no measurement is carried out and no
Switching Off
– To switch the detection tool off, press the On/Off
radar, transmitter
– When switching off the detection tool, all
Switching the Audio Signal On/Off
The audio signal can be switched on/off with the
audio signal button 13. The "Tone signal" can be
changed in the "Settings" submenu (see "Tone
Signals", page 12).
-10-
tool when not using it for extended periods.
When storing for long periods of time, the
batteries can corrode and discharge themselves.
On/Off button 15 or the start button 11.
indicated on display 16.
button is pressed for 5 minutes, the detection
tool switches off automatically. This "Cut-off
time" can be changed in the "Settings" menu
(see "Cut-off Time", page 12).
button 15.
settings are retained in the menus.