Descargar Imprimir esta página

Maytag Precision Touch 850 Serie Guía De Uso Y Cuidado página 17

Ocultar thumbs Ver también para Precision Touch 850 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Oven Cooking
Pilotless Ignition
Your range is equipped with pilotless ignition. With this type of
ignition system, the gas automatically shuts off and the oven
will not operate during a power failure.
A lighted match will not light the oven burner. No attempt
should be made to operate the oven during a power failure.
Oven Fan
A convection fan is used to circulate hot air in the oven when
the convection feature is selected. It automatically turns on 5
minutes after the Convect Bake or Convect Roast pads are
pressed and will turn off when convection is canceled.
Note: The convection fan will automatically stop when the
oven door is opened.
Oven Vent
When the oven is in use the area near the vent may become
hot enough to cause burns. Never block the vent opening.
The oven vent is located below the backguard on your
range.
When high moisture foods are cooked in the upper oven,
steam may be visible coming from the oven vent. This is
normal.
Oven Lights
The oven lights automatically come on whenever an oven
door is opened. When the door is closed, press the Oven Light
pad to turn the oven light on or off. A beep will
sound every time the Oven Light pad is pressed.
Oven Bottom
Protect oven bottom against spillovers, especially acidic or
sugary spills, as they may discolor the porcelain enamel. Use
the correct pan size to avoid spillovers and boilovers. Do not
place aluminum foil directly on either oven bottom. Do
not place pans on the oven bottom while baking or
roasting in the upper or lower oven. You may place pans
on oven bottom for broiling in upper oven only.
OVEN VENT
LOCATION
Do not place
plastics near the
vent opening as
heat from the vent
could distort or
melt the plastic.
Oven Racks
• Do not attempt to change the rack position when the oven
is hot.
• Do not use the oven for storing food or cookware.
All racks are designed with a lock-stop edge.
Upper oven
• Is equipped with one rack and rack
position.
• When pulling the upper oven rack out to
remove or check food, grasp the top edge
of the rack.
Lower oven
• Is equipped with one RollerGlide
racks.
To remove oven racks:
• Pull rack straight out until it stops at the lock-stop position;
lift up on the front of the rack and pull out.
• For RollerGlide
TM
rack, pull both the rack glide and rack
base out together.
To replace oven racks:
• Place rack on the rack support in
the oven; tilt the front end up
slightly; slide rack back until it
clears the lock-stop position; lower
front and slide back into the oven.
Baking with the RollerGlide
(Lower oven only)
• For optimal baking results when baking on one rack, use
TM
the RollerGlide
rack.
• When baking on two racks, use the RollerGlide
the top rack position, and the flat rack in the lower rack
position.
16
CAUTION
TM
rack and two regular flat
TM
Rack
TM
rack in

Publicidad

Capítulos

loading