Bresser MyTime 8020312 GYE000 Instrucciones De Uso página 7

Automatic time setting via DCF time signal
After inserting the battery the time will be set auto-
matically via DCF signal. This process may take a few
minutes. During this process, the clock hands will turn
several times with interruption until they will display the
right time.
Initiate to receive the DCF time signal manually
NOTE!
Use this function when e.g. automatic summer/winter
time change does not work or the wall clock temporar-
ily receives no time signal.
1. Press and hold the REC button (7) for 3 seconds to
start manual search for the DCF signal.
2. The clock hands will move to their start position
(12:00 a.m.) and a the wall clock then tries to re-
ceive the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.
Manual time setting
NOTE!
It is necessary to set the time manually in places
where no radio signal is received.
1. Press and hold the M.SET button (5) for approx.
3 seconds.
2. When the minutes hand starts moving you can the
set the time manually:
• Press the M.SET button shortly to set the time in
minutes steps.
• Press and hold the M.SET button to set the time
continuously.
3. Release M.SET button to stop manual setting and
save the time automatically and exit manual time
setting mode.
MOUNTING/POSITIONING
NOTE!
Make sure you have mounted or placed the device in
a safe way. Otherwise the device may fall down and
heavy damages can occur for which the manufacturer
is not liable.
The wall clock can be mounted on walls with the wall
mount (3).
TROUBLESHOOTING
Transmission collision
Signals from other household devices, such as door
bells, home security systems and entry controls, may
interfere with those of this product and cause tempo-
rarily reception failure. This is normal and does not
affect the general performance of the product. The
transmission of the radio signal will resume once the
interference recedes.
Other malfunctions
If there is no response from the wall clock by key-
strokes or if any other malfunctions occur perform the
following steps.
NOTE!
With this procedure all received data will be deleted.
1. Press RESET button (6) with a pointed instrument
(e.g. pen).
2. The clock hands will move to their start position
(12:00 a.m.) and the wall clock then tries to receive
the signal.
3. Wait approx. 2-5 minutes until the current time will
be displayed.
CLEANING AND MAINTENANCE
Before cleaning the device, disconnect it from the
power supply (remove batteries)!
Only use a dry cloth to clean the exterior of the de-
vice. To avoid damaging the electronics, do not use
any cleaning fluid.
Protect the device from dust and moisture. The batter-
ies should be removed from the unit if it has not been
used for a long time.
DE
GB
FR
IT
ES
7