Tools Needed - Bosch 00634736 Manual De Instalación

Installation of 00634736 - Kit, Corner Covers, Gas

Tools Needed

• Torx T20 screwdriver
• gloves
• 1¼ wrench (if range height needs adjustment)
Preparation
IMPORTANT!
If the range is already installed, can the range slide out
enough to give access to the side screws of the rear trim?
See Figure 1: Identify right and left corner covers and
Figure 2: Rear trim side screw location.
• If the range is not yet installed or can slide out,
continue to the Procedure.
• If the range is already installed and cannot slide out,
contact a qualified service technician to disconnect the
gas or electrical connections that prevent the range
from being pulled out before continuing to the
Procedure.
• Read the Tip Over Warning in the Safety section of this
manual. Be aware of this when the range has been
pulled out of the anti-tip bracket for corner cover
installation.
Procedure
1. Confirm that the range surfaces and cooktop grates are
cool enough to be comfortably touched.
2. Identify which corner cover is to be attached to the left
(A) and right (B) rear of the range. See Figure 1:
Identify right and left corner covers.
Figure 1: Identify right and left corner covers
3. Slide the range out enough to access the rear trim side
mounting screws (see Figure 2: Rear trim side screw
location). Read the Proper Handling Technique Notice
in the Safety Section of this manual.
4. Remove only the two side screws holding the rear trim
(one on each side); see Figure 2: Rear trim side screw
location. Save these screws to attach the corner
covers. If there are no screws in these locations,
screws are included in the kit for this purpose.
Figure 2: Rear trim side screw location
English 3