Controllable Functions - LGB Tm 91 RhB Manual Del Usuario

Function Mapping DCC
It is possible to assign functions controlled from the decoder to function buttons
of your choice (mapping). To do this an appropriate value must be entered in the
appropriate CV.
The CVs (lines) and the functions (columns) are listed in the tables on pages 40/41.
Four CVs belong to each button. For space reasons the 4 CVs were put together in
one line starting with CV 282 (Button F5).
It is basically possible to assign several functions to one button or one function to
several buttons.
Note: The programming for function mapping should be done only by experienced
users.
Individual functions can be controlled by means of SUSI depending on the design of
the decoder. These functions can be handled by the decoder as sound. The volume
levels belonging to these functions cannot be changed.
Examples of Function Mapping:
AUX 2 is to be forwards and backwards on Function 3
CV 272 & CV 372 = 8
CV 273 & CV 373 = 0
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
Sound 15 is to be shifted from forwards and backwards on Function 3 to Function 8.
The existing function at Function 8 is overwritten in the process.
CV 275 & CV 375 = 0
CV 273 & CV 373 = 0
away from Function 3
CV 274 & CV 374 = 0
CV 275 & CV 375 = 0
CV 297 & CV 397 = 0
CV 298 & CV 398 = 0
to Function 8
CV 299 & CV 399 = 0
CV 300 & CV 400 = 4

Controllable Functions

Lighting (Swiss headlight changeover) *
Sound effect: Long Horn
Sound effect: Squealing brakes off
Sound effect: Short Horn
Sound effect: Cab radio (randomly)
Sound effect: compressor
Sound effect: Operating sounds
Engineer's cab lighting
Sound on/off
ABV, off
Double A switching light
Headlights rear off
Headlights front off
Sound effect: compressed air
Sound effect: sanding
Sound effect: Garage noises (randomly)
* active in analog operation
12
LV/LR
1 Sound 1
2 BS
3 Sound 2
4 Sound 15
5 Sound 11
6 FS
7 AUX 3
8 Sound 8
9
10 LV/LR
11 AUX 2
12 AUX 1
13 Sound 13
14 Sound 10
15 Sound 14