Toyotomi Zibro LC-130 Instrucciones De Uso página 10

J
THE CORRECT USE OF 'SAVE'
The SAVE function allo s you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
e ceeds the set temperature by 3 C. Subse uently,
dropped again to the set temperature, the heater will automatically switch on again.
Activate the SAVE setting by pressing the appropriate
light ill light up ( ig. J). S itch off the function by pressing the SAVE key once
again.
Without the SAVE setting your heater
!
appro imation as
setting, which you can use when, for instance, you are not present in the room or
to keep it frost-free.
K
THE 'FUEL' INDICATOR
When the UEL indicator appears, it means that there is only fuel left for 10
more minutes. The count-do n of the remaining heating time can be seen in the
information display ¸ ( ig. K).
You remove the fuel tank and refill it outside the living room (Section B).
In the display the number 10 will appear, you will hear an alarm signal every
two minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
hen it s itches off. The fuel indicator
blinking in the information display. You can stop this by pressing the
¹ once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDICATOR
When the VENT indicator starts blinking, this is a sign that the room is not vented
sufficiently ( ig. L). The heater
continues blinking after extra ventilation, please contact your dealer.
M
MAINTENANCE
S itch off the heater and let it cool do n, before you start any maintenance
ork. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance. It is, however, important that you clean the vent filter
vacuum cleaner and the grid
Regularly inspect the fuel filter as well:
1 Remove the removable tank
( ig. M). Some drops may leak from the filter keep a cloth at hand.
2 emove the dirt by tapping the fuel filter upside-do n against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
4
10
ill maintain the set temperature by
ell, by adjusting its heating capacity. SAVE is an economy
ill s itch off automatically. If the indicator
with a damp cloth, both on a weekly basis.
from the heater and remove the fuel filter
hen the room temperature has
key. The SAVE indicator
ill blink, hile four lines (--:--) are
J: When the SAVE light
lights up, the heater will
automatically switch on
or off in order to remain
within a specified tem-
perature range.
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
button
L: A blinking VENT
indicator is a sign
that you need extra
ventilation.
with a
Fuel filter
M