Toyotomi Zibro LC-130 Instrucciones De Uso página 8

E
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted,
the adjustment keys
keys to switch on the function (the °C mark ¸ will start blinking). Next, adjust the
temperature using the key on the right ( min.) to set the temperature to a higher
setting and the key on the left ( hour) to lo er the temperature. Press once to
increase the value one step. After appro imately 10 seconds the C mark
blinking and the setting
The available temperature settings range from
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
F
USING THE TIMER
The timer allows you to switch on the heater automatically at a preset time.
In order to switch on the timer, the correct time must have been set (refer to
Section C) and the heater should be off. ollo
1 Press the button ¹ and then the TIMER key
The TIMER lamp
2 Use the adjustment keys
Use the key on the left (
( min.) to set the minutes (interval of 5 minutes).
3 After appro imately 10 seconds the 4-digit
TIMER lamp
activated ( ig. H).
4 The timer will ensure that the room will have been heated to approximately
the re uired temperature at the set time.
!
When you want to switch off the heater and ignite it again with the timer, all
you have to do is press the TIMER key (refer to Section G).
Press the button ¹ once to clear the timer setting.
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater:
1 Press the button ¹. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2 Press the TIME key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function. You can change the re uired time
the adjustment keys
4
8
to adjust the temperature. irst press either of the t o
ill be locked ( ig.
and the 4-digit ¸ will start blinking.
to set the time at which the heater must ignite.
hour) to set the hours and the key on the right
will light up, indicating that the timer function has been
, when you want to switch off the heater and ignite it
(refer to Section F).
hen the heater is burning. Use
).
C minimum to 28 C ma imum.
the procedure belo :
immediately after that.
ill sho CLOCK again and the
ill stop
H: The TIMER indicator
light indicates that the
timer function has been
switched on.
ith