Bushnell TOUR Z6 JOLT Manual De Instrucciones página 6

GETTING STARTED
OPERATIONAL SUMMARY
While looking through the Tour® Z6™ Jolt, depress the power button once to activate the Vivid Display. Place the
aiming circle (located in the center of the field of view) upon a target at least 5 yards away, depress and hold the power
button down until the range reading is displayed near the bottom of the in-view display. Crosshairs surrounding the
aiming circle indicate that the laser is being transmitted. Once a range has been acquired, you can release the power
button. The crosshairs surrounding the aiming circle will disappear once the power button has been released (i.e. the
laser is no longer being transmitted).
Note: Once activated, the display will remain active and display the last distance measurement for 7 seconds. You can depress the power button again at any
time to distance to a new target. As with any laser device, it is not recommended to directly view the emissions for long periods of time with magnified lenses.
The maximum time the laser is transmitted (fired) is 7 seconds. To re-fire, press the button down again.
ADJUSTING THE EYEPIECE
Your Tour® Z6™ Jolt is constructed with a fold-down eyepiece designed for comfort and to exclude extraneous light.
The Tour® Z6™ Jolt provides extra-long eye-relief. If you wear glasses, make sure the eyecup is in the down position
as this will bring your eye closer the eyepiece lens allowing you to see a full field of view. The Tour® Z6™ Jolt is also
equipped with an adjustable eyepiece (+/- 2 Diopter Adjustment) that allows one to focus the VDT™ display relative
to the image. Simply rotate the eyepiece until the red display is in focus.
6