Oil Change/Filling; Belt Transmissions Check; Steering; Checks - Stiga Park series Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 145
EN

9 .5 .2 Oil change/filling (14)

For the frequency of this intervention
see chapter 13 .
For the type and quantities of fluid re-
quired, please refer to "0 TECHNICAL
DATA TABLE" .
Use oil with no additives.
Change the oil when the engine is warm.
The oil may be very hot just after the
engine has been switched off. Conse-
quently allow the engine to cool down
for a few minutes before proceeding to
drain off the oil.
Proceed as follows:
1 . Place the machine on a flat surface.
2 . Apply the parking brake.
3 . Open the bonnet.
4 . Grab the clamp on the oil drain hose (9:E).
Use polygrip pliers or similar.
5 . Move the clamp 3-4 cm up the oil drain hose
and pull out the plug.
6 . Collect the oil in a suitable vessel.
7 . Hand the spent oil over to a disposal facility
in accordance with local provisions.
8 . Replace the oil drain plug and move the
clamp back over the plug.
9 . Clean up any spills.
10 . Remove the dipstick and fill with fresh oil. For
the quantities of oil required, please refer to
"0 TECHNICAL DATA TABLE".
11 . After filling up the oil, start the engine and
leave it to idle for 30 seconds.
12 . Turn off the engine. Wait for 30 seconds and
then check the oil level again as indicated in
heading 9.5.1.
9 .6

BELT TRANSMISSIONS CHECK

check that all belts are intact.
For the frequency of this intervention
see chapter 13 .
9 .7

STEERING

For the frequency of this intervention
see chapter 13 .

9 .7 .1 Checks

Gently turn the steering wheel back and forth.
There must be no mechanical play in the steering
chains.
18
ENGLISH

9 .7 .2 Adjustment (17)

Adjust the steering chains if required as follows:
1 . Put the machine in the straight-ahead posi-
tion.
2 . Adjust the steering chains by means of the
two nuts, located under the central point
(17:A).
3 . Adjust both nuts by the same amount until
there is no play.
4 . Test drive the machine, moving it forward in
a straight line and checking that the steering
wheel is not off centre.
5 . If the steering wheel is off centre, slacken
one nut and tighten the other.
Do not over tension the steering chains .
This would make the steering too stiff
and increase wear on the chains.
9 .8

BATTERY

For the type of battery installed on the machine,
please refer to "0 TECHNICAL DATA TABLE"
Acid can cause serious injuries if it co-
mes into contact with eyes or skin. If
any part of the body comes into contact
with acid, rinse immediately with co-
pious amounts of water and seek medi-
cal attention immediately .
The battery fluid does not need checking or top-
ping up. The only maintenance operation required
is charging, for example after extended storage.
The battery can be charged:
- by the engine,
- by a battery charger "GGP".

9 .8 .1 Charging by the engine

This method is only an option if there is still
enough charge in the battery to be able to start the
engine.
• Take the machine outside.
• Start the engine by following the instructions
provided in this manual.
• Leave the engine running continuously for 45
minutes (the time needed to fully charge the
battery).
• Turn off the engine.

9 .8 .2 Charging with a battery charger "GGP"

Use a constant voltage battery charger .
Use of a standard charger may damage
the battery .
(Translation of the Original Instructions)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Park 120Park 220V 302V 302 s

Tabla de contenido