Insuring Your Lawnmower; Assembly; Assembly Components; Bonnet - Stiga Park series Manual De Uso

(Translation of the Original Instructions)
• Adhere strictly to local regulations governing
the disposal of cuttings.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.

4 INSURING YOUR LAWNMOWER

Check the insurance on your lawnmower.
Contact your insurance company.
You ought to have fully comprehensive insurance
for traffic, fire, damage and theft.

5 ASSEMBLY

The battery must be fully charged befo-
re being used for the first time.
Do not use the machine until all the in-
dications provided in the "ASSEMBLY"
section have been carried out .
Unpacking and completing the assem-
bly should be done on a flat and stable
surface, with enough space for machi-
ne handling and its packaging, always
making use of suitable equipment .
5 .1

ASSEMBLY COMPONENTS (3)

The machine is delivered with the seat, steering
wheel and bonnet dismantled. The battery is in its
housing but not connected.
The packaging holds the components needed for
assembly (3) as listed in the table below:
Pos. No. Description
A 2 Plug
B 4 Screw
C 2 Shoulder washer
D 2 Ignition key
E 1

Bonnet

F 1 Lifting pulley
G 2 Quick-release supports
- 1 Documentation kit
5 .2 BONNET (5)
Open the bonnet to access the fuel cap and
engine oil cap.
Install the bonnet (5:A) as follows:
4 . Insert the hinge in the groove (5:B) on the
guard (5:C).
5 . Press firmly to get the hinge into the two slots
(5:D)
ENGLISH
6 . Open and close the bonnet to check that it
5 .3
For the type of battery installed on the machine,
please refer to "0 TECHNICAL DATA TABLE"

5 .3 .1 Battery connection

5 .3 .2 Battery charging

5 .4
1 . Remove the following components from the
2 . Position the seat on the seat bracket
Dimensions
6 x 36
3 . Put the shoulder washers (6:B) on the
16 x 38 x 0,5
16 x 38 x 1,0
4 . Insert the screws (6:A) and the shoulder wa-
/
/
Tightening torque: 24 Nm.
/
The seat can be folded. If the machine is parked
outside where it is exposed to rain, fold the seat
forward to protect the seat cushion from getting
wet.
opens and closes correctly.

BATTERY

WARNING! Battery acid is corrosive
and contact with it is harmful. Handle
the battery with care taking care not to
let acid leak out .
Note: To connect the battery, contact an
authorized technical assistance servi-
ce .
The battery must be fully charged befo-
re being used for the first time.
Please refer to 9 .8 for the battery char-
ging procedure .

SEAT (6)

NOTE! To facilitate installation of the
seat, apply a drop of oil to the four
screws before screwing them in.
seat bracket:
•
4 Nuts (for blocking during transport, not
used).
• 4 Screws.
•
2 Shoulder washers.
mounting.
screws.
shers (6:B) in the slots on the seat support
and the holes on the seat plate as illustrated
in figure 5. Screw the seat into place.
Tightening the screws to a torque over
24 Nm, will damaged the seat.
EN
11