Maruyama M270QC Manual Del Propietário página 18

1. Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank.
(Flowing fuel should be almost clear, not foamy or
full of bubbles.)
2. Move the choke lever to the closed (
And move the control lever to the high speed side
approximately half in from the low speed side.
Choke Lever
L:
Low speed
H:
High speed
Fast-idle lock button
3. Grasp the throttle lever then push the fast-idle lock
button. Release your hand with holding the fast-
idle lock button to lock the fast-idle.
4. Pull the starter grip.
) position.
Starter Grip
Throttle Trigger
Control Lever
Throttle Lever
POTENTIAL HAZARD
• The components of your recoilstarter
assembly are under high spring tension.
If improperly disassembled these parts
maystrike you with considerable force,
possibly causing personal injuly.
WHAT CAN HAPPEN
• Contact with the parts can cause severe
personal injury.
HOW TO AVOID THE HAZARD
• Never attempt to disassemble your
recoil starter assembly yourself.
Always consult your authorized
MARUYAMA dealer for repair by
qualified service technicians.
• Do not pull the Starter rope all the way
out.
5. After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip
with the throttle trigger positioned at Fast-idle
position.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the
carburetor until fuel can be seen flowing through
the fuel return line to the fuel tank. (Flowing fuel
should be almost clear, not foamy or full of
bubbles.)
2. Move the choke lever to the open (
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (page US-16).
— US-17 —
WARNING
CAUTION
) position.
) position:
) position.