Attaching Strap; Before Operation; Oil And Fuel - Maruyama M270QC Manual Del Propietário

Detaching
1 First, loosen the clamping knob before detaching
the shaft assembly to the shaft coupler.
2 Pull out the shaft assembly from the shaft coupler
while holding the positioning lever down.
3 Note : Do not over loosen the clamping knob or it
may fall out.
Positioning Lever
Clamping Knob
Loosen

Attaching Strap

Snap the strap hook into the ring on the drive shaft. To
detach the strap quickly from the Brushcutter, pull
upward on the red band.
WARNING
POTENTIAL HAZARD
• Without the strap installed on the
Brushcutter, the blade can produce side
thrust which can expose the operator
and bystanders to blade contact.
WHAT CAN HAPPEN
• Contact with the Brushcutter blade can
cause personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Brushcutter without
installing and using the strap.
Push down
Shaft Assembly
Removal
— US-14 —
Red Band
Pull
Hook
Ring

Before Operation

Oil and Fuel

DANGER
POTENTIAL HAZARD
• In certain conditions gasoline is
extremely flammable and highly
explosive.
WHAT CAN HAPPEN
• A fire or explosion from gasoline can
burn you, others, and cause property
damage.
HOW TO AVOID THE HAZARD
• Use a funnel and fill the fuel tank out-
doors, in an open area, when the engine
is cold. Wipe up any gasoline that spills.
• Do not fill the fuel tank completely full.
Add gasoline to the fuel tank until the
level is 1/4 to 1/2 in. (6 mm to 13 mm)
below the bottom of the filler neck. This
empty space in the tank allows gasoline
to expand.
• Never smoke when handling gasoline,
and stay away from an open flame or
where gasoline fumes may be ignited
by a spark.
• Store gasoline in an approved contain-
er and keep it out of the reach of chil-
dren.
• Never buy more than a 30-day supply of
gasoline.
Strap