Side Tank Accessory - GE Profile XPIO13BCBT Manual Del Usuario

Ocultar thumbs Ver también para Profile XPIO13BCBT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Side Tank Accessory

NOTE: There are two drain tubes located on the back of your Opal Nugget Ice Maker indicated as drain tube A and B
in the illustration on page 12.
1. H and Wash Only: Rinse and hand wash Opal Side
Tank with warm water and a mild dish soap. Remove
Opal Side Tank's cap and wash the cap and rubber
valve with water and a mild dish soap. The Side Tank
base can be washed by disconnecting the hose and
adding a small amount of soapy water to it. Scrub as
needed and rinse thoroughly. The rinse water should
drain out the port in the back.
Rinse the cap, rubber valve, tank and the base well to
remove any residual soap (see illustration).
DO NOT WASH THE SIDE TANK IN THE
DISHWASHER.
2. U nplug Opal Nugget Ice Maker. Unhook Opal's drain
tubes and drain the water from the reservoir.
3. C onnect drain tube, labeled B, to the back of Opal Side
Tank's base.
4. Make sure drain tube (A) is connected to the black
hanger and installed on the back of Opal.
5. M ake sure drain tube (B) connecting to the Side Tank
is resting flat on the countertop.
6. P lace Opal Side Tank on the right or left-hand side of the the Opal Nugget Ice Maker. Using the side tank attachment,
slide the shorter side of the attachment under the unit, near the front of the unit. The attachment will slide into a slot on
the bottom of the unit. Once this is placed, the side tank can slide onto the opposite attachment. See figures below and
on next page.
NOTE: Care should be taken to connect the correct tube to the Opal Side Tank. Tube (B) should always be
connected to the Side Tank whether it is installed on the left or right side of the Opal Nugget Ice Maker. It is
important to make sure the tube is lying flat, otherwise water may not flow from the side tank into the ice maker.
Tube B
attached to
the side tank
49-1000464 Rev. 1
Side Tank
Cap and
Valve
B
A
Unplug this
drain tube (B)
from the black
hanger and
connect this
tube to the
Side Tank.
Plug drain tube B
into the side tank
here.
Tube B
attached to
the side tank
11

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Profile xpio13scssProfile xpio23bcbtProfile xpio23scss

Tabla de contenido