Making Ice; Draining; Water Filter - GE Profile XPIO13BCBT Manual Del Usuario

Making Ice with Opal
Once Opal has been cleaned/sanitized, move the ice maker to its desired location and complete the following steps.
1. R emove ice bin.
2. F ill reservoir with potable (safe to drink) water up to
the "Max Fill" line. Water hardness must be less than
12 grains per gallon. Do not fill reservoir with any
liquid except water. Using any liquid except potable
water is misuse and will void your warranty.
3. Plug the ice maker into a grounded outlet.
4. Touch the Power button to start the ice maker. The
indicator on the left-hand side will light up 'Making Ice'
to confirm that unit has begun to make ice.
5. O pal will begin to produce ice in 15-30 minutes. It will
continue to make ice until the bin is full, or it runs out
of water. To continue making ice, just add more water.
Draining Opal
We recommend draining your Opal when:
1. Y ou put it away or anytime it's being relocated
2. You turn it off for more than a few days. (i.e. vacation)

Water Filter

The Opal Water Filter, is available at GE Appliances
and is the only water filter compatible with Opal. Please
follow the installation instructions included with your filter.
Water filter snaps into place
10
Side View
3. You are not using much ice. Continous recirculation
of meltwater may affect taste. For best results, drain
your Opal.
NOTE: Remove your water filter (if installed) and
reinstall the screened intake cap prior to cleaning your
Opal.
Water Filter
Max fill line
Water Reservoir
Front View

Making Ice

Add Water Clean Light Power
Defrosting Cleaning Hold 3 Sec
49-1000464 Rev. 1