Backless Booster Seat - Diono monterey XT LATCH Manual De Instrucciones

BACKLESS BOOSTER SEAT

While this booster seat is designed to offer advanced side-impact protection
with its backrest section attached, the seat bottom can also be used alone
as a backless booster.
1. Remove the seat back by reversing the steps shown in "Seat Assembly."
2. Make sure both LATCH connectors are securely attached to the
vehicles lower anchors (see "Lower Anchor Installation"). While
pushing booster against vehicle seat, pull the adjuster straps tight.
3. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the
vehicle seat back. The entire seat bottom should
sit flat on the vehicle seat.
4. Properly position child: sitting upright and all the
way back in the booster seat.
5. Fasten seat belt across child.
6. Make sure seat belt is not twisted and lays flat
across child's hips, torso and shoulder.
7. Tighten the seat belt by pulling the diagonal
shoulder belt portion in the direction of the arrows.
NEVER position the shoulder belt loosely or under the child's arm or
behind their back.
22
1-855-463-4666
USING THE SHOULDER BELT GUIDE STRAP
1. Remove shoulder belt guide strap from storage area underneath seat.
2. Position child correctly in seat as per the prior instructions in the
manual, making sure lap and shoulder belts are positioned properly
across child.
3. Attach the red shoulder belt guide strap onto
the diagonal shoulder belt.
4. Adjust strap to correct length, so that the red
guide is just above shoulder.
WARNING! If the diagonal seat belt portion does not correctly fit the
child, then the seat must be used with the shoulder belt guide strap or
with the seatback portion attached and properly adjusted to fit the child.
BACKLESS BOOSTER SEAT
diono.com
23