Installation - Diono cambria 2 Manual De Instrucciones

INSTALLATION

WARNING! Unsecured objects can become flying hazards and can cause
serious injury in an accident. If your vehicle is equipped with lower
anchors, Diono always recommends installation utilizing the LATCH
connectors with this booster seat.
To improve safety and performance, this booster seat is equipped with a
lower anchorage system that allows secure attachment to a vehicle's
lower anchor locations.
1. Disengage LATCH connectors from storage slots
and lay booster seat on its side. While depressing
the cam lock lever, gently pull LATCH connectors
away from the booster seat and extend both straps
all the way. Do not overextend connector straps.
2. Attach both LATCH connectors to the vehicle
anchors, starting with the connector that is
furthest from you. For ease of use, make sure
open end of hooks face upward during use.
3. While pushing booster against vehicle seat, pull
one adjuster strap tight and then the other. Make
sure that both LATCH connectors are securely
attached to the vehicles lower anchors.
NOTE: Even with LATCH connectors properly
attached and adjusted, child seat will still have
movement against the vehicle seat back and bottom.
16
1-855-463-4666
IMPORTANT:
seat belt.
IMPORTANT:
sure it is stable and does not rock from side to side.
ADJUSTING THE RECLINE ANGLE
This booster seat features a recline angle that can be
adjusted to match that of the vehicle seat:
1. Push booster seat backrest backwards until you
1
hear a click. Backrest will now pivot freely and
does not need to click into another position.
2. Push seat bottom and backrest of booster seat
down and back into vehicle seat until there is
secure positioning with the booster seat and
vehicle seat bottom and vehicle seat back. A
2
gap is acceptable as long as the head support is
touching the vehicle seat back or head rest.
IMPORTANT:
booster seat to match that of the vehicle seat.
3
Do not use LATCH if installation interferes with vehicle
When using booster seat in center seating position, make
It may also be necessary to adjust the recline angle of the
diono.com
INSTALLATION
17