Troubleshooting - Briggs & Stratton Speed Clean Manual Del Operario

Troubleshooting

Problem
Pump has following problems:
failure to produce pressure, erratic
pressure, chattering, loss of
pressure, low water volume.
Unit fails to start when spray gun
trigger is squeezed.
Detergent fails to mix with spray.
18
Cause
1. Water inlet is blocked.
2. Inadequate water supply.
3. Garden hose is kinked or leaking.
4. Clogged water inlet screen.
5. Water supply is over 100°F (38°C).
6. High pressure hose is blocked or leaks.
7. Nozzle is obstructed.
8. Pump is faulty.
1. Water supply is not turned on.
2. Unit is not turned on.
3. Garden hose is too long.
1. Siphon tube is clogged or cracked.
2. Siphon tube is not fully inserted in
detergent tank.
3. Wand adjustment setting is incorrect.
Correction
1. Clear inlet.
2. Provide adequate water flow.
3. Straighten garden hose or replace if leaking.
4. Check and clean water inlet screen.
5. Provide cooler water supply.
6. Clear blocks in high pressure hose or
replace hose.
7. Clean nozzle.
8. Contact Briggs & Stratton service facility.
1. Turn on water supply.
2. Press the master ON/OFF switch to the
Pressure Washer ON ( | ) position. Reset
GFCI.
3. Use only 50 ft. (15.24 m) maximum garden
hose.
1. Clean or replace siphon tube.
2. Insert siphon tube so that end contacts
bottom of detergent tank.
3. Adjust wand setting as instructed in
Applying Detergent.
BRIGGSandSTRATTON.COM