Connect Foam Lance; Checklist Before Starting Pump Motor - Briggs & Stratton Speed Clean Manual Del Operario

Connect Foam Lance

1. Insert the adjustable fan jet wand (A) into spray gun (B). Once
wand slides into gun, apply further inward pressure to wand
and twist 1/4 turn clockwise until securely in place.
A
2. Slide the foam lance (C) onto the adjustable fan jet wand (D).
Apply further inward pressure to wand until you hear a CLICK
and the locking tab (E) falls into place over the lip (F) of the
wand. Tug on foam lance to make sure it is securely in place.
D
3. To remove foam lance, lift up on locking tab (E) and pull it
away from the wand.
B
C E
F

Checklist Before Starting Pump Motor

Review the unit's assembly to ensure you have performed all of
the following.
1. Be sure to read Operator Safety and Operation before using
the electric pressure washer.
2. Check for properly tightened hose connections.
3. Check to make sure there are no kinks, cuts, or damage to
hoses.
4. Provide a proper water supply at an adequate flow.
5. Plug electrical cord into a properly grounded electrical source.
11