Connect Hoses And Water Supply; Connect Wand - Briggs & Stratton Speed Clean Manual Del Operario

Connect Hoses and Water Supply

NOTICE Use ONLY cold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
2. Run water through garden hose for 30 seconds to flush the
hose of debris. Turn off water.
3. Confirm that water inlet screen (A) is installed in water inlet
located at lower front of unit; Do Not remove except for
cleaning.
C
A
B
NOTICE If inlet screen is damaged or missing, DO NOT use
electric pressure washer. Call (800) 743-4115 for assistance.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
5. Attach high pressure hose (D) to the unit's water outlet (E)
located at lower back of unit. Tighten by hand.
D
6. Attach opposite end of high pressure hose to the spray gun.
Press red button (F) on spray gun, then insert end of high
pressure hose (G) into gun until it SNAPS into place. Release
the red button and make sure connection is secure.
F
G
10
E

Connect Wand

1. Turn ON water, point gun in a safe direction, press trigger
release (H), then squeeze trigger (J) to purge pump system
and spray gun of air and impurities.
2. Insert and twist desired wand (K) into spray gun (M). Once
wand slides into gun, apply further inward pressure to wand
and twist 1/4 turn clockwise until securely in place.
K
3. Turn OFF water and release trigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.
H
J
M
BRIGGSandSTRATTON.COM