Assemble Main Unit - Briggs & Stratton Speed Clean Manual Del Operario

Assemble Main Unit

When performing the following assembly procedures, pay close
attention to the illustration at the bottom of this page.
1. Slide wheel shafts (A) into holes at sides of main unit (E).
Wheels are installed correctly when you hear a CLICK and
they are securely in place.
2. Slide the handle (B) into the slots at top of main unit. Install
two (2) screws to secure the handle to the main unit.
A
8
D
E
3. Slide accessory tray (C) into slots at back of main unit. Install
two (2) screws to secure the accessory tray to the main unit.
4. Match the contour of the decorative handle molding (D) with
that of the handle. Slide decorative handle molding into handle
opening until it snaps into place.
B
A
C
BRIGGSandSTRATTON.COM