Husqvarna T540XP II Manual Del Usuario página 3

15. Bar tip sprocket
16. Saw chain
17. Guide bar
18. Throttle trigger
19. Throttle trigger lockout
20. Belt eyelet
21. Clutch cover
22. Chain tensioning screw
23. Product and serial number plate
24. Chain catcher
25. Spiked bumper
26. Oil pump adjustment screw
27. Guide bar cover
28. Operator's manual
29. Combination wrench
Symbols on the product
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Chain brake, engaged (right). Chain brake,
disengaged (left).
Air purge bulb.
Adjustment of the oil pump.
Fuel.
Chain oil.
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
524 - 005 -
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle with
actuated chainbrake, CKA wb.
Husqvarna H37
16 Max 9T
yyyywwxxxx
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirement. Maintenance,
Work position.
Choke.
Recommended cutting
equipment in this exam-
ple: Guide bar length 16
in, maximum nose radius
9 Teeth and chain type
Husqvarna H37.
Handle insert dimension.
The rating plate shows se-
rial number. yyyy is the
production year and ww is
the production week.
3