Automatic Defrost Function; Auto Off Function - UFESA DH4012 Manual De Instrucciones

FAN SPEED SETTING
You may adjust the fan speed.
1
Press the silencio button (E) to select low fan speed.
● To return to the high fan speed press the silencio
button again.
For maximum dehumidification
performance, set the high speed fan.
If the level of humidity in the room is
reduced and silent operation is required,
set the low fan speed.

AUTOMATIC DEFROST FUNCTION

If frost appears on the evaporator' s coils, the compressor
turns off, and the fan will run until frost is removed.
Automatic defrost indicator (K) lights up.

AUTO OFF FUNCTION

If the water tank (4) is removed, improperly installed or
overfilled, water level control switch turns the appliance
off. In this case, water tank full indicator (I) lights up and
the display shows P2 error code.
If the operating appliance is switched
off after the water tank is full, it will
automatically start when empty water
tank is installed correctly. After 3 minutes the
appliance will automatically restart in
accordance with the last used settings.
Remove the collected water
There are two methods of removing the collected
condensate:
USING WATER TANK
Water may be collected in the water tank (4).
The dehumidifier automatically turns off
when the water tank is full. Water tank
full indicator lights up and the display
shows P2 error code.
1
Grab the holders on the sides of the water tank (4)
with both hands and carefully slide it out.
G
When ejecting the water be careful not
to splash the water!
Do not place the full tank on the floor
or other surfaces, as the bottom of the
tank is uneven and water may spill!
2
Empty the tank as shown on the picture.
3
Install the tank in the appliance so that it securely
and properly fits in its place.
The appliance will not operate with
missing or incorrectly attached water
tank.
When installing the water tank make
sure that its mounting location is dry.
If not, let it dry.
When installing/removing the water
tank, do not touch any parts inside the
appliance!
● After correct installation of the water tank, the
dehumidifier starts automatically after 3 minutes in
accordance with the last used settings.
Do not remove the water tank during
operation. This may cause water flow
out from the drain opening.
Do not use the drain tube when using
a water tank. If the tube is connected,
the water flows through it on the floor
rather than into the tank.
THROUGH THE DRAIN TUBE
H
If the dehumidifier is operated at very high levels of
humidity, water from the tank must be drained more
often. In this case, it is convenient to use continuous
drainage.
Water may be automatically drained from the appliance
through an installed drain tube with an inner diameter
of 12 mm (not included).
1
Remove the drain plug (11).
2
Connect the drain tube with a diameter of 12 mm
to the drain opening (10).
I