Cleaning And Storage - UFESA DH4012 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Make sure that the connection between
the drain tube and the drain opening is
tight!
● Put the drain tube into the drain hole in the floor.
The drain hole must be below the drain
opening of the appliance.
● Make sure the drain tube is not kinked or squashed.
Drain tube the must provide a continuous
flow of water on its entire length.
It cannot be bent, squashed or tangled.
3
After the operation, disconnect the drain tube from
the drain opening (10).
4
Insert the plug (11) into the drain opening (10).
When the water tank is used to collect
the water, disconnect the drain tube and
insert the plug into the drain opening.

Cleaning and storage

Always turn off and unplug the appliance
from the wall outlet before cleaning.
Do not wash any part of the dehumidifier
in the dishwasher.
CLEAN THE AIR INLET / OUTLET GRILLE AND
HOUSING
● Use water and a mild detergents to clean the
housing (2).
● Do not use bleach, powders or abrasive sponges and
cloths.
● Use a brush or a suitable vacuum cleaner attachment
to clean the air inlet (3) and outlet (8) grille.
Make sure that no water enters the
inside of the appliance during cleaning!
This may cause an electric shock due to
deterioration of insulation or corrosion of the
appliance.
CLEAN THE WATER TANK
Clean the water tank (4) every few weeks to prevent
the growth of bacteria, mould, and bad odours.
● Partially fill the water tank (4) with clean water, add
a small amount of mild detergent.
● Shake the tank, empty and then rinse.
● Clean the tank from the outside with a soft, dry cloth.
AIR FILTER REMOVAL AND CLEANING
Clean the air filter (5) at least every 30 days or more
often to prevent the growth of bacteria, mould, and bad
odours.
An optimum frequency of air filter
cleaning recommended by the
manufacturer: every 14 days.
1
Remove the water tank (4) (See section Removing
the collected water).
2
Grab and press the air filter holder (6).
3
Pull and eject the air filter (5) down.
4
Wash the filter in warm soapy water. Then rinse
and let it dry completely.
5
When completely dry, install the air filter back in
place. A characteristic "click" means that the filter is
properly installed.
6
Install the tank in the appliance so that it securely
and properly fits in its place.
Make sure that the filter is correctly
installed.
Do not use the dehumidifier without the
filter installed, as it will cause the
accumulation of impurities and reduce
the performance of the appliance, and
consequently may cause damage to the
appliance.
APPLIANCE STORAGE FOR EXTENDED
PERIODS OF TIME
If the appliance is not used for an extended period of
time:
● Turn off the appliance and unplug the power cord (12)
from the wall outlet.
● After one day after turning the appliance off, empty
the water tank (4).
J

Publicidad

Tabla de contenido
loading

Tabla de contenido