Remote Control Procedures - Luminance Brands Kathy Ireland Home CF144LGRT00 El Manual Del Propietario

8.1: Preset Memory Feature
Your Receiver is equipped with a preset memory
feature . If the AC supply to the Receiver is powered
through a Wall Switch, when the Switch is turned OFF,
the Control will remember the Light Intensity and Fan
Speed .
When the Switch is turned back ON the Light and Fan
will resume operation as they were prior to the Switch
being turned OFF .
8.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Control (Figure 25) .
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations .
The Five Levers (numbered 1, 2, 3, 4, and 5) on
the Switches are factory-set in the ON (up) position .
Change the Switch settings as follows:
Slide the Five Switch Levers in the Remote Control to
your choice of ON (up) or down positions . Use a ball-
point pen or small screwdriver and slide the Levers
firmly up or down .
The Sixth Switch marked ON and I is for dimming
control of lights: Set Switch to ON to allow for dimming
of the lights . Set Switch to I for no dimming of the lights .
NOTE: If your fan and light go on and off without
using your control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.

8. Remote Control Procedures

!
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
Figure 24
NOTE: Never use old and new batteries together in
unit.
BATTERY
COMPARTMENT
COVER
Figure 25
To remedy this situations, simply change
the Combination Code in your Remote Control
Transmitter.
16
WARNING
REMOTE CONTROL
LEVERS
ON
1
2 3 4 5 I
CODE
SWITCHES
REMOTE CONTROL
U.L. Model No.: CF144L & CF152L