Husky F2S26VWDVP Manual Del Operador página 13

APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this tool for the purposes listed below:
g Operating some light duty air powered tools.
g Inflating tires, air beds, sports equipment, etc.
(Inflation accessories sold separately)
TURNING THE AIR COMPRESSOR ON/OFF
See Figure 4.
g Turn the power switch to the ON position to power the
compressor on.
g To turn the air compressor off, turn the power switch to the
OFF position.
USING THE AIR COMPRESSOR
See Figures 4-5.
g Ensure power switch is in the OFF position and air
compressor is unplugged.
g If not already installed, attach hose to compressor as
previously instructed.
g Attach 1/4 in. NPT male connector fitting of tool and into
female couple end of air hose.
WARNING
Always ensure the switch is in the OFF position and the
regulator pressure gauge reads zero before changing air
tools or disconnecting the hose from the air outlet. Failure
to do so could result in possible serious personal injury.
g Rotate regulator knob clockwise to open air flow.
g Connect the power cord to the power supply.
g Turn the switch ON.
g Rotate pressure regulator knob to desired line pressure.
Turning the knob clockwise increases air pressure at the
outlet; turning counterclockwise reduces air pressure at
the outlet.
g Following all safety precautions in this manual and the
manufacturer's instructions in the air tool manual, you
may now proceed to use your air powered tool.
OPERATION
QUICK-CONNE CT
WARNING
Your tool may require more air consumption than this air
compressor is capable of providing. Check the tool
manual to avoid damage to the tool or risk of personal
injury.
g If using an inflation accessory, control the amount of air
flow with the pressure regulator knob. Turning the knob
fully counterclockwise will completely stop the flow of air.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed will drain air from the tank more rapidly and
cause the unit to cycle on more frequently.
g When finished, always drain the tank and unplug the unit.
Never leave the unit plugged in and/or running unattended.
(See page 15 for draining instructions.)
Page 11
ON OFF
OFF/ON
1/4 in. QUICK
COU PLER
AIR FITTIN G
Figure 4
Figure 5