Adjustments - RIDGID R2200 Manual Del Operador

ADJUSTMENTS

ADJUSTING LOCK LEVER TENSION ON THE
FIXED BASE ROUTER
See Figure 20, page 18.
Over time and with repeated use, the lock lever may become
loose. When this occurs, tighten the stop nut slightly. The
stop nut should be loose enough so that there is some play
in the lock lever when it is in the open position.
NOTE: Do not over tighten the stop nut. The lock lever should
clamp tightly to secure the motor housing.
CAUTION:
Make sure the motor housing does not move
up or down when clamped. If motor is not
securely clamped in base, adjustments will not
be accurate.
WARNING:
Follow the proper provided instructions from the
router table manufacturer when mounting router
to a routing table. Failure to use router tables with
appropriate safety features could result in serious
personal injury. Use router tables that are UL
classified and identified suitable for use with the
specific router model.
CENTERING TOOL
See Figures 21 - 23, pages 18 - 19.
If the subbase needs to be replaced, removed, or changed,
a centering tool is provided. The 1/4-in. collet adaptor must
be removed before the centering tool can be used.
To remove the subbase on the router:
 Unplug the router and stand it upside down.
 Remove the three (3) subbase screws on the base.
 Remove the router subbase.
To install the centering tool and subbase:
 Unplug the router and stand it upside down.
 Unlock the lock lever and adjust the depth adjustment
knob (raising or lowering the base). Center the depth
interlock lever with the lock lever.
 Place the lock lever in the the "locked" position.
 Place the subbase on the base and insert the subbase
screws.
 Tighten screws lightly so that the subbase can move
freely.
 Hold the collet nut with the supplied wrench and depress
and hold the spindle lock until it locks into place.
 Loosen the collet nut, be sure the 1/4 in. adapter has
been removed from the 1/2 in. collet.
 Insert the large end of the centering tool pin into the collet
until it touches bottom. Pull centering tool upward until
the tapered edge is flush with the subbase. Tighten the
collet securely with the wrench provided.
 Release the spindle lock.
 Place the centering cone on the centering tool and lightly
press down on the cone until it stops as shown in figure
20. This will center the subbase.
 While pressing down on the cone, tighten the subbase
screws.
To remove the centering tool:
 Unplug the router.
 Hold the collet nut with the supplied wrench and depress
and hold the spindle lock until it locks into place.
 Loosen the collet nut and remove the centering tool.
 Release the spindle lock.
ROUTER TABLE ATTACHMENT
See Figure 23, page 19.
When attaching the router to a routing table, remove the
subbase, and use the router table attachment screws pro-
vided with the router. Use these screws to replace the sub-
base screws shown in figure 23.
ATTACHING/REMOVING VACUUM ADAPTOR
See Figure 24, page 19.
 Unplug the router.
 Using the supplied screws, place the vacuum adaptor on
the base with the openings in the vacuum adaptor lined
up with the screw holes on the back of the base.
 Insert the supplied vacuum adaptor screws.
 Turn screws clockwise with a screwdriver to tighten.
 To remove, turn screws counterclockwise.
13 - English