Carlson Pet Products 0730 PW Manual Del Usuario página 4

STEP 7
RECEIVING COMPONENT
OUTER HOUSING
When you are satisfied with the general placement of your
gate, fully tighten the threaded spindle rods attached to the
lower corners of the gate by further rotating the adjustment
wheels. Continue by tightening the upper threaded spindle
rods. As you tighten the threaded spindle rods, you will
notice the gap between the door frame and the secure slide
latch begin to narrow. In order for the gate to function
properly, stop tightening the upper threaded spindle rods
just before the outer housing of the secure slide latch and the
receiving component touch.
There should be equal spacing among each of the
NOTE:
(4) threaded spindle rods. Make the appropriate
adjustment to ensure you have installed your gate safely.
Positioning and Attaching Wall Cups
STEP 1
After you have mounted your gate, and you are satisfied
with its positioning, draw a circle on the surface of your
doorway or opening around the perimeter of the (4)
rubber feet.
Next, completely remove the gate from the opening
by loosening each of the (4) threaded spindle rods to
depressurize the gate.
Operating the Door Latch
STEP 1
Push the circular button on the secure slide latch
while simultaneously pulling back. These two
actions combined will disengage the lock and
allow the gate to open freely.
Push or pull to open the gate door. To close, simply
push or pull the door back into its original position.
The secure slide latch will re-engage automatically
and lock the door into its closed position.
If your secure slide latch is not properly
NOTE:
engaging with the receiving component, ensure that
your gate is level, mounted properly, and that you
have not over-tightened the threaded spindle rods.
STEP 2
With gate fully removed, you can now use the circles you
marked during Step 1 as guides for screwing in your (4)
wall cups (F). Center each of the wall cups within the guide
circles and use the provided self-tapping screws (G) to
fasten them in place via the hole through the center of
each wall cup.
STEP 2
LOCKING SLIDE
CIRCULAR
BUTTON
BASE LOCK
At the bottom of the gate door, rotate the base
lock to the horizontal position. To allow the
door to swing open in only one direction rotate
the base lock on one side. To allow the door to
swing open in both directions, rotate the base
lock on both sides.
NOTE:
the child.
STEP 3
Reinstall your gate in the doorway or opening
according to the instructions, using the newly installed
wall cups as anchoring points for the (4) threaded
spindle rods.
Place lock down on side occupied by