Preparing The Installation Cavity - Bosch B18 Serie Instrucciones De Instalación

Fix the hinge box cover.
̈
6.

Preparing the installation cavity

m
WARNING
Assure that there are no electrical wires or plumbing in
the area which the screws could penetrate.
Risk of injury and damage!
NOTE
– 2 anti-tip-brackets are required for each appliance
or appliance combination (Side-by-Side).
– If possible, always screw the wooden beam to
existing studs on the rear panel of the cavity.
– In some installations the sub-flooring or finished floor
may necessitate angling the wood screws used to
fasten the anti-tip-brackets to the back wall.
– The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
– If the supplied fastening screws do not permit
secure attachment of the anti-tip brackets and
therefore the appliance, another method must be
used to attach the anti-tip brackets securely.
Specify the attachment points of the anti-tip-brackets.
̈
Specify the detailed dimensions according to the
section on "Installation dimensions" starting on page 9.
If the installation cavity is deeper than the appliance,
̈
place a solid wooden beam behind the anti-tip-brackets
and attach securely to the base or the wall.
The length of the wooden beam is equal to the width of
the installation cavity!
Wood floor application
m
Use the wooden screws provided, see overview diagram
"Use the screws in the screws set".
Drill pilot holes:
̈
1
/ " (3 mm) for the (5 x 60 mm) wooden screws
8
5
/ " (2 mm) for the (4 x 15 mm) wooden screws
64
Being certain the screws penetrate through the flooring
and into the wall plate a minimum of
Attach the anti-tip-bracket completely. Be sure screws
̈
hold tight.
3
/ " (19 mm).
4
21