Preparing To Connect The Water - Bosch B18 Serie Instrucciones De Instalación

Mark the installation height (lower edge of the beam) on
̈
the rear panel of the cavity.
Select screws according to the thickness of the wooden
̈
beam: length = min. 2.5 x beam thickness, diameter
#12 or #14.
Specify the number of screws according to the
cavity width, thereby ensuring that the beam can be
attached securely.
According to the subsurface:
Locate wall studs near the rear panel of the cavity and
̈
mark drill holes in the beam
or
Fasten suitable dowel into the rear wall.
̈
Predrill the wooden beam.
̈
Attach the wooden beam to the rear panel of the cavity.
̈
NOTE
8.

Preparing to connect the water

(only for appliances which require a water connection)
m
CAUTION
Turn off the main water tap to prevent damage caused
by leaking water.
Attach the connecting pipe to the shut-off valve
̈
according to the instructions supplied by the
manufacturer of the ice maker installation kit.
Install the connecting pipe.
̈
Always observe the indicated gap dimensions to
prevent damage to the connecting pipe when pushing
in the appliance.
Attach the connecting pipe to the floor with adhesive
̈
tape.
m
23