Weber GENESIS E 310, GENESIS EP 310 Guia Del Usuario página 20

Burner Tube Removal
To remove burner tube(s):
A) Remove igniter wire(s) from igniter clip(s) (9) .
B) Remove screw that holds burner tube to the cookbox using a 5/16" nut-driver (10) .
C) Pull burner tube assembly (this includes igniter) up and out of cookbox (11) .
Note: 310 units will have an additional grounding wire attached to the center burner
tube (12).
Burner Tube Cleaning
To clean the burner tube(s):
A) Look inside each burner with a flashlight (13) .
B) Clean the inside of the burners with a wire (14) (a straightened-out coat hanger will
work) .
C) Check and clean the air shutter opening at the ends of the burners . Check and
clean the valve orifices at the base of the valves . Use a steel bristle brush to clean
outside of burners (15) . This is to make sure all the burner ports are fully open .
m CAUTION: Do not enlarge the burner ports when cleaning.
Burner Tube Reinstallation
To reinstall burner tubes:
A) Slide burner tube and igniter wire through hole in cookbox (16) . Refer to
"ELECTRONIC IGNITION SYSTEM OPERATIONS" for proper burner position .
B) Align burner tube with valve .
m CAUTION: The burner openings (17) must be positioned
properly over the valve orifices (18).
C) Re-install screw that holds the burner tube to the cookbox using a flathead
screwdriver . Burner tube may seem loose (19), when screw is snug . This is normal .
D) Route wires back through igniter clips . Refer back to figure (9) .
m CAUTION: All wires must be properly routed through wire
clips.
E) Attach wires to module, following the numerical/color coding (20) . Refer to
"ELECTRONIC IGNITION SYSTEM OPERATIONS" for proper attachment of wires .
m WARNING: After reinstalling the gas lines, they should be
leak checked with a soap and water solution before using
the grill. (Refer to "CHECK FOR GAS LEAKS".)
m WARNING: Make sure that all parts are assembled and
hardware is fully tightened before operating the grill. Your
actions, if you fail to follow this Product Warning, may
cause a fire, an explosion, or structural failure resulting
in serious personal injury or death as well as damage to
property.
◆
20
MAINTENANCE
9
11
13
14
16
19
10
12
15
17
18
20