Wolf M Serie Guia De Instalacion página 10

Ocultar thumbs Ver también para M Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Electrical Connection
The terminal block on the back of the range allows for a
3-wire or 4-wire installation. Remove the terminal block
cover to expose the screws with corresponding numbers.
Route the wires through the strain relief and to the termi-
nal block.
THREE-WIRE INSTALLATION
Move the metal ground strap to positions one and two.
1
Refer to the illustration below.
Connect green/ground to position one.
2
Connect red/L2 to position three.
3
4
Connect black/L1 to position four.
Tighten the screws on the strain relief and install the
5
terminal block cover.
FOUR-WIRE INSTALLATION
1
Remove the metal ground strap.
Connect green/ground to position one.
2
3
Connect white/neutral to position two.
Connect red/L2 to position three.
4
5
Connect black/L1 to position four.
Tighten the screws on the strain relief and install the
6
terminal block cover.
6
5
4
3
REMOVE
2
1
Three- and four-wire
10 | Wolf Customer Care 800.222.7820
6
5
4
3
INSTALL
2
1
Three-wire only
Gas Supply Connection
All connections to the gas piping must be wrench-tight-
ened. Do not overtighten or allow pipes to turn when
tightening.
If a flexible metal connector is used, verify it is not kinked,
then attach the gas supply line to the gas inlet on the
range. Open the valve and check for leaks by placing a
liquid detergent solution onto all gas connections.
Bubbles around the connections indicate a gas leak.
If a leak appears, close the shut-off valve and adjust the
connections.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido