Troubleshooting - Wolf M Serie Guia De Instalacion

Ocultar thumbs Ver también para M Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Door Alignment
To adjust the door, follow these steps:
1
Remove the skirt by extracting the screws.
Open the door, and loosen the nut. Refer to the
2
illustration below.
Close the door, and turn the screw clockwise to raise
3
and counterclockwise to lower the door.
Open the door, and tighten the nut.
4
5
Close the door, and reinstall the skirt.
ADJUSTMENT
SCREW
NUT
SKIRT
Door alignment
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.

Troubleshooting

IMPORTANT NOTE: If the range does not operate properly,
follow these troubleshooting steps:
Verify electrical power is supplied to the range.
Verify the gas supply shut-off valve is in the open
position.
If the range does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
range. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com | 11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido