Maintenance; Enviromental Protection - Truper MOTO-AI Manual De Instrucciones

On/Off Switch
• To start the tool, press the on/off switch (A).
• To stop the tool, press the on/off switch again.
• This tool has been set to the slowest
CAUTION
speed before switching on.
Speed Adjustment
• To achieve the best result when working with different
materials, you can adjust the tool speed with the variable
speed control button. Press the "+" speed button to
increase the speed and press the "-" speed button to
decrease the speed.
• Select a low speed when working with wood, plastics
and polishing.
• The 5 blue speed indicators (B) indicate the 5 levels of
speed, the speed is corresponding from 5 000 to 25 000
RPM.
• The rotary tool uses a high-grade lubricant. It ensures lubrication the tool's full working life when used in regular
conditions. Does not need further lubrication.
• Inspect regularly all the mounting screws and double-check they are tightly secured. Loose screws present a high risk.
Cleaning and Storage
• Do not use aggressive cleaning products, metal brushes,
sharp or metal utensils, otherwise the rotary tool housing
gets damaged.
• Clean the housing with a soft and dry cloth.
• Remove dirt with a humid cloth and mild detergent.
• Never submerge the rotary tool in water or other type
of liquids.
• Dry the rotary tool thoroughly before storing.
• Load the battery full before storing the rotary tool for
long periods of time. Storing unloaded batteries or
partially discharged may cause a deep discharge. This,
destroys the batteries cells and makes them useless.
• Store the rotary tool out of the reach of children. Keep
it in a locked placed with a storing temperature ranging
between 41 °F and 68 °F
Power tools and batteries should not be disposed off together with household trash. Please deliver this tool and the
batteries to its adequate recycling in the authorized disposal sites. Verify the nearest recycling center in your community.
10
ENGLISH
Start Up
Drilling Operation
• Turn the tool on to full speed. Apply the tool to the
workpiece gently.
CAUTION
pressure will only cause a poor finish and overloading of
the motor.
Holding the Tool
• For milling or engraving, hold the tool like a pen. Take
care not to cover the ventilation slots.
CAUTION
operation. Observe the rated operating time.

Maintenance

Service and repairs
• In the event the tool is not working properly go to an
• Service and repairs should only be made in a
and maintenance performed by non-qualified people may
be dangerous and can lead to personal injuries. It also
makes the product Warranty void.
• Use only original
Otherwise there you may be exposed to accidents and
make the Warranty void.
Environmental protection
B A
Apply light pressure on the tool. Excessive
The tool will get warm during normal
Authorized Service Center.
Authorized Service Center. Service
spare parts.