Kenwood KDC-BT740DAB Manual De Instrucciones página 20

Bluetooth®
• Depending on the Bluetooth version, operating system and the
firmware version of your mobile phone, Bluetooth features may not
work with this unit.
• Be sure to turn on the Bluetooth function of the device to make the
following operations.
• Signal conditions vary depending on the surroundings.
Connect the microphone
Connect the supplied microphone to the microphone input jack on the rear
panel.
Adjust the
microphone
angle
Pair and connect a Bluetooth device for the first time
1 Press B SRC to turn on the unit.
2
Search and select the name of your receiver ("KDC-BT740DAB") on the
Bluetooth device.
"PAIRING" "PASS XXXXXX"
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
12
Secure using cord
clamps (not supplied)
if necessary.
"Device name" "PRESS" "VOLUME
Once pairing is completed, Bluetooth connection is established
automatically.
• "BT1" and/or "BT2" indicator on the faceplate lights up.
• " " indicator lights up to show the strength of the battery and signal of
the connected device.
Answer a call
Press or the volume knob or one of the number buttons (1 to 6).
• To adjust the phone volume [00] to [35], turn the volume knob.
• To end a call, press .
Audio player via Bluetooth
1 Press B SRC repeatedly to select BT AUDIO.
2
Operate the audio player via Bluetooth to start playback.
To
Play back/pause
Select group or folder
Reverse skip/Forward skip
Reverse/Fast-forward
Repeat play
Random play
On the faceplate
Press 6 IW.
Press 2 / 1 .
Press .
Press and hold .
Press 4 repeatedly.
Press and hold 3 to select [ALL RANDOM]
or [GROUP RANDOM].