Sony VPL-DX270 Manual De Referencia Rápida página 47

Connecting to an external device
INPUT C
For connecting an external device with an HDMI output terminal. Connect the external device
to INPUT C.
HDMI output
terminal
External
device
Supplying the power to the external device
The unit supplies power (5V/2A maximum) via the USB cable to the external device (stick type
PC, etc.).
1
Connect the unit to the external device using the USB cable (with type A USB
terminal).
USB terminal
(Type A)
Stick type external devices with HDMI
output terminal, such as wireless devices,
small-sized PC, etc. (not supplied)
Notes
• Use external devices with the appropriate specification for using this unit.
• If you connect the unit in wrong ways, the external device may cause a malfunction. In this
case, Sony assumes no responsibility.
2
Set "Power Supply" to "On" in the Connection/Power menu.
The unit supplies power to the external device through the USB cable.
Notes
• Only VPL-DX270/DX240/DW240 has the INPUT C terminal.
• Use HDMI-compatible equipment and cable(s) that have an HDMI logo on them.
• The HDMI terminal of this projector is not compatible with DSD (Direct Stream Digital)
Signal or CEC (Consumer Electronics Control) Signal.
• Use a high speed HDMI cable(s) on which the cable type logo is specified. (Sony products are
recommended.)
• The maximum resolution of the INPUT C terminal is set to 720p.
HDMI cable
(not supplied)
USB cable
(type A USB terminal)
Power supply
terminal
Connecting
15
GB