Metabo HPT G 3612DA Manual De Instrucciones página 17

It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
Fig. 10
State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50% – 75%.
Lights ;
The battery remaining power is
25% – 50%.
Lights ;
The battery remaining power is
less than 25%
Mode
Transmission
Dial Settings
Auto
Remaining battery
indicator switch
Table 5
Battery Remaining Power
Status Number of Revolutions (/min)
1
2
3
4
5
A
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
9 About the mode change function
The unit has "Transmission mode" and "Auto mode".
○ With Transmission mode, the grinder's number of
revolutions can be set at one of fi ve stages.
When operating in Transmission mode, the set
number of revolutions will be maintained regardless
of changes in load.
○ With Auto mode, you can lower noise and vibration by
lowering the maximum number of revolutions while in
a no-load state.
While in Auto mode, the number of revolutions will be
raised if the load becomes greater during operation.
On the other hand, the number of revolutions will
be lowered if the load decreases during operation.
(Table 6)
○ Set the mode and dial according to work application.
Table 6
3000
4750
6500
8250
9500
5500
9500
English
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible.
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow it
to fully cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem
may be the battery so please
contact your dealer.
Use
Grinding stainless steel
Rust or paint removal
Grinding, fi nishing
Rough grinding, cutting
Light work, Standby state
Grinding, cutting
17