Pentair FRESHPOINT F1000-DFB Manual De Instalación Y Funcionamiento página 5

INSTALLATION CONTINUED
3. Mounting the Faucet
A. Apply 3-5 wraps of plumber tape to faucet stem.
B. Assemble faucet as shown in (Figure 3).
C. Screw quick connector onto threaded end of faucet stem.
D. Place a mark 5/8" from one end of the blue tubing. Wet the
end of the 3/8" tube and push into bottom of connector. The
5/8" mark should be flush with the collar of the connector.
NOTE: To remove the tube, push on the fittings' collar and pull
the tube out.
E. Holding the faucet, feed the tubing through the hole in the
sink. Position the faucet handle at a desired location.
F. Center the faucet and slip slotted disc between the bottom
of the counter or sink and lock washer. Tighten the stem
nut with a wrench until it is tight.
G. Firmly insert spout into faucet base.
4. Mounting the System
A. Select a location under the sink, or other suitable area
where the system will be installed.
NOTE: The system carton can be used to determine the
operational footprint required for installation of the
system and replacement cartridges. (Figure 4a)
B. Mount the system vertically. Dimensions in the diagram
allow for cartridge or system removal. Ensure mounting
is level. Use the 3/32" drill bit to create pilot holes for the
mounting (Figure 4b).
The system should be mounted to a firm, solid
WARNING:
surface that is able to support the weight of the
system.
4b
2 3/8"
(60.3 mm)
3
Faucet Stem
Chrome
Plate
Rubber
Washer
Slotted
Disk
Lock Washer
Stem Nut
Quick
Connector
3/8" Tubing
4a
13.5" (343 mm)
FRESHPOINT F1000-DFB, F1000-B1B Filtration Systems Instruction Manual • 5
Counter Top
7" (178 mm)
Inlet
7.875" (200 mm)
Outlet