Compatible Pictures - Panasonic PT-LB10NTU Instrucciones De Operación

TV-SYSTEM
(S-VIDEO/VIDEO only)
T V - S Y S T E M
This should normally be set to
"AUTO". If the signal is of such poor
quality that the correct format
cannot be automatically
distinguished, change the setting
manually to the required TV system.
NOTE:
B When set to "AUTO", the
projector automatically
distinguishes between
NTSC/NTSC 4.43/PAL/PAL60/
PAL-M/PAL-N/SECAM signals.
STILL MODE
(S-VIDEO/VIDEO only)
To reduce flickering of still images
(vertical flicker), set "STILL MODE"
to "ON".
NOTE:
B Set to "OFF" when playing
back moving images.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
A U T O
[
N T S C
[
N T S C 4 . 4 3
[
P A L
[
P A L - M
[
P A L - N
[
S E C A M
SIGNAL MODE
(RGB/YP P /NETWORK only)
B R
This displays the type of signal
which is currently being projected.
Refer to the list on page 60 for
details on each type of signal.
Projecting sRGB-

compatible pictures

sRGB is an international color
reproduction standard (IEC61966-2-
1) established by the International
Electrotechnical Commission (IEC).
If you would like the colors in sRGB-
compatible pictres to be reproduced
more faithfully, make the following
settings.
# Press the F F or G G button to
select "PICTURE MODE", and
then press the I I or H H button
to select "NATURAL".
$ Press the STD (standard)
button on the remote control
unit.
% Press the F F or G G button to
select "COLOR TEMP.", and
then press the I I or H H button
to select "STANDARD".
NOTE:
B sRGB is only enabled when
RGB signals are being input
(when "LAMP POWER" is set
to "HIGH" and "AI" is set to
"OFF").
E -39
NGLISH